User's Manual

 If the setting is “off,” no code will be sent to the CMS.

 When the Base Station is in idle mode, you can toggle on/off the

inactivity timer by pressing the yellow button once (if the yellow button

has been programmed as an away/home button).

7. Inactivity Interval:

 This function monitors user movements and sends an inactivity report

to the CMS if the user fails to reset the inactivity timer before the

interval expires. This setting is for you to select the countdown period

for the inactivity timer.

 The inactivity timer can be reset by pressing the reset button once on

the Base Station, by inserting the Mobile Unit on the Base Station, or

by an action from any device with a button.

 When the inactivity timer expires and no reset signal is received, the

Base Station will start to play a voice prompt every five minutes to alert

the user during warning time. If a reset signal is still not received after

warning time expires, an inactivity alarm report will be made.

 The reporting method for an inactivity alarm is the same as that for an

emergency alarm. The report will be sent based on your reporting

methods after the warning time expires.

8. Inactivity Warning Time:

 Inactivity warning time is the interval between the expiry of the

inactivity timer and the Base Station’s sending an inactivity alarm

report to the CMS.

 The Base Station will play a voice prompt upon the expiry of the

inactivity timer. Afterwards the voice prompt will be played every 5

minutes during warning time as a reminder to the user until the expiry

of warning time.

 If warning time is disabled, an inactivity alarm report will be

immediately sent to the CMS upon the expiry of the inactivity timer.

9. Callback Time:

 This setting is for digital reporting methods. After reporting

successfully to the CMS, the system will automatically hang up the

line and start a waiting period (=callback time) to auto answer any

incoming calls from the CMS.

 When the CMS calls back within callback time, the system will auto

answer the call after the first ring and wait for the entry of the proper

Access Code followed by the (#) key within 15 seconds.

 When the correct Access Code is received, the system will open

full-duplex communication to allow the call recipient to speak to the

CMS directly. You can use DTMF commands to switch