User's Manual

31
Step 7. Non-Emergency Call
 Click “Non-Emergency Call” to program the non-emergency call number
and click “Write.”
 When the Base Station is in normal mode, you can make a
non-emergency call by pressing the green reset button for 3 seconds or
press the yellow button once (if the yellow button has been programmed
as a non-emergency call button). The Base Station will emit 2 beeps and
automatically dial the programmed non-emergency call number for
two-way communication.
 During the conversation of a non-emergency call, you can enter the
following DTMF commands:
- Enter (1) to talk only.
- Enter (2) to open two-way voice communication.
- Enter (3) to listen in only.
- Enter (9) to hang up. You can also put the handset back to the base
cradle to end the call.
 During the conversation of a non-emergency call, you can extend the
communication by entering DTMF command (1), (2) or (3).
 At 20 and 10 seconds before the communication time expires, 1 beep will
be emitted via the telephone handset to alert the user. When the
communication time is up, the call will be automatically terminated.
 The communication time of non-emergency calls is conditioned by the
two-way timer function.