User's Manual

3. Getting Started – Installing Mobile Pers

3.1. Setting up the Base Station

Step 1. Choose a suitable location for the Base Station. The Base Station

requires the mains power and PSTN/Ethernet connections (PSTN for

MP-2 and MP-5; Ethernet for MP-3 and MP-5) and should be easily

accessible. It should not be placed in a damp location such as a

bathroom or close to a heat source like a microwave oven, which

could reduce signal strength.

Step 2. Plug the USB cable into the Base Station’s USB port and connect to a

PC for Mobile Pers programming.

Step 3. Connect a PSTN line and a telephone line to the Base Station for

Mobile Pers to operate via PSTN (MP-2 and MP-5 only).

Step 4. Plug an IP cable into the Base Station’s Ethernet port and connect to

an Ethernet network for Mobile Pers to operate via Ethernet (MP-3

and MP-5 only).

Step 5. Plug the AC power adaptor into the Base Station’s DC jack and

connect to the mains power. The Base Station will emit two beeps to

indicate the system is now ready for further operation.