User's Manual

 Mounting Methods
 Mount the Door Contact using one of the below mounting methods: Velcro tape Mounting or Screw Mounting.
 Mount the magnet on the more mobile object (such as door) using either the double-sided adhesive pad or the screws provided.
 Align the magnet according the rib mark on Door Contact. Where required, use the Magnet Spacer to better align the magnet to
the rib marks.
< NOTE >
 The magnet should be no more than 15mm from the detector when the door is closed.
Mounting Methods for the Door Contact
 Screw Mounting
The back cover has two Mounting Holes (knockouts), where the plastic is thinner, for mounting purpose.
To mount the Door Contact:
I. Remove the cover (See Installation above).
II. Break through the knockout on the back cover.
III. Using the holes as a template, drill both holes.
IV. Insert wall plugs if fixing into plaster or brick.
V. Screw the back cover into the wall plug using a Philips screwdriver.
VI. Attach the front cover to the back cover (see Pic 3 ~ 5 above).

Velcro tape Mounting:
The Door Contact can be wall mounted using Velcro tape provided.
I. Clean the wall mounting location and back of the Door Contact with degreaser. Do not mount on wall with cracking paint or
rough surface.
II. The Velcro tape can be separated to Hook and Loop side.
III. Remove the protective cover of the Hook side and attach to the back of the
Door Contact. Press firmly for 30 seconds to ensure good contact. (Pic 6.)
IV. Remove the protective cover of the Loop side and apply to desired
mounting location as in (Pic 7.) Press firmly for 30 seconds to ensure good
contact.
(Pic 6.) (Pic 7.)
V. Apply the Door Contact on the Loop side Velcro taped on the wall (Pic 8 & 9.)
(Pic 8.) (Pic 9.)
Hooks
Loops
3