Product Info

 Reset Remote Keypad to Factory Default
The Remote Keypad can be reset to clear all learnt-in data and return all settings to default value by following the steps
below:
1. Please follow Change of Battery steps for factory default.
2. Within 10 seconds after inserting batteries, enter “0000”. When the last digit of “0000” turns into “” on the LCD screen,
press “#” to reset the Remote Keypad to default value.
3. “Reset Default” will be displayed on the LCD screen along with 3 beeps indicating successful operation.
4. All learnt-in data will be cleared.
5. Entry/ Exit Beeps will be disabled.
6. Alarm Beep will be disabled.
7. Dual Key alarm function will be disabled.
<
<
N
N
O
O
T
T
E
E
>
>
 Factory default setting can only be performed within 10 seconds after inserting batteries. If the keypad is not wake
.up within 10 seconds after inserting batteries, remove batteries and try again.
 Whenever the Keypad is removed from the Control Panel, it should be put to factory reset as well to clear its
.Control Panel memory.
 Mounting Remote Keypad
To mount the Remote Keypad:
1. Remove the front cover by loosening the cover fixing screw using a screwdriver.
2. Use the 4 mounting holes on the back cover as a template to mark and drill mounting holes.
3. Drill 4 holes and insert the wall plugs. Ensure the wall plugs are flush with the mounting surface.
4. Screw the back cover onto the wall plugs.
5. Replace the front cover onto the back cover. Screw the cover fixing screw.
6. The installation is now complete.
7