Product Info

 Press the OK key once. When “Enter PIN Code” is displayed on the LCD screen, press and hold the OK key for 10
seconds.
 “KP will reset in 2 seconds” will be displayed on the LCD screen along with a long beep.
 “Scanning Network” will be displayed on the LCD screen while the Remote Keypad is sending learning code to the
Control Panel.
 When the Keypad is added into the Control Panel, “Learning Success” will be displayed on the LCD screen along
with 2 beeps.
<
<
N
N
O
O
T
T
E
E
>
>
 If the Control Panel promptly responds to the Remote Keypad, the “Scanning Network” process will be skipped,
.and “Learning Success” will be directly displayed on the LCD screen.
 If the Remote Keypad does not receive any signal from the Control Panel within 30 seconds, the LCD screen will
.be turned off, and the Remote Keypad will return to stand-by mode.
Hardwiring Operation:
In addition to the wireless operation to join in the system network as stated above, the user can do it through
hardwiring.
Step 1. Connect the Keypad to the Panel through wiring.
Step 2. Choose a located area and a free zone to join in the system network.
C
h
o
o
s
e
A
r
e
a
&
Z
o
n
e
A
n
d
E
n
t
e
r
C
o
d
e
s
。
A
r
e
a
1
A
r
e
a
2
。
Z
o
n
e
1
Z
o
n
e
3
Step 3. Enter the PIN Code of the located area.
E
n
t
e
r
P
I
N
C
o
d
e
Step 4. Enter Installer Code. (Factory Default: 7982)
E
n
t
e
r
I
-
C
o
d
e
Step 5. The Keypad is added to the located area and the zone you chose.
A
d
d
e
d
K
e
y
p
a
d
T
o
A
r
e
a
1
Z
o
n
e
1
 Fault Conditions
When Remote Keypad is under NORMAL OPERATION MODE,
 If the Control Panel is in Away Armed mode, you CANNOT activate Home Armed Mode by using Remote Keypad. If
you do so, the Remote Keypad will emit 2 beeps indicating the Control Panel is in Away Armed mode.
 When any fault situation is detected, the Yellow LED will flash once every 3 seconds. The Yellow LED behavior is
decide by the Control Panel.
 If there are 5 incorrect PIN Code attempts within 10 minutes, the Remote Keypad will be automatically locked up for
5 minutes. During this period, any operation will be invalid. When the lockup time expires, the Remote Keypad will
emit 1 long beep.
 Change of Battery
1. Go to the Control Panel programming menu to bypass the KP tamper alarm.
2. Dismount the Remote Keypad.
3. Take out all three old batteries and press the tamper switch for more than 3 seconds to fully discharge before replacing
new batteries. Do not mix new and old batteries.
4. Take out the old battery and press the tamper switch to discharge before replacing the new battery.
5. Screw back the Remote Keypad to the surface with mounting screws.
6. Put the Control Panel back to normal operation mode.
6