Product Info

The Keypad Terminal can be hardwired to the Control Panel in series within 500ft (152m) in wire distance.
 KPT-35-COMBO-A is wired correctly as it is within 500ft (152m) of the Control Panel, in wire distance.
 KPT-35-COMBO-B is wired correctly as it is within 500ft (152m) of the Control Panel, in wire distance. Before tightening
the cover fixing screw of the keypad, ensure its jumper switch is set to ON to serve as a terminating resistor since it has
the furthest distance from the Control Panel.
 KPT-35-COMBO-C is NOT wired correctly as it is farther than 500ft (152m) from the Control Panel.
 Tamper Protection
 The Remote Keypad is protected against any unauthorized attempt to open the back cover with a tamper switch. When
the back cover is opened, the tamper switch will be triggered and the Remote Keypad will transmit a tamper open signal
to the system control panel.
 After replacing the back cover, the Remote Keypad will transmit a tamper restore signal to the system control panel.
 When the Remote Keypad is properly mounted with back cover screwed onto the wall, removing the Keypad forcefully
will break off the back cover from the hollowed section around the screw location and activate tamper switch.
 Supervision Signal
 After installation, the Remote Keypad will automatically transmit Supervision Signals to the Control Panel at an interval
of 30-50 minutes.
 If the Control Panel has not received the signal from the Remote Keypad for a preset period of time, the Control Panel
will consider the Remote Keypad out of order and react according to panel setting.
 RFID Configure
This function is for you to manage your RFID device (Tag)
 RFID Learn:
Up to 60 Tags can be learnt into the Remote Keypad. To learn the new RFID device into the Remote Keypad:
1. In the User Menu, choose Setting > RFID Config > RFID Learn.
2. Use

and

key to select the RFID # you want to use for learning new RFID, and then press the OK key to
confirm selection.
3. “Apply RFID” will be displayed on the LCD screen. Please put the tag close to the RFID sensor within 5 seconds.
4. When the Keypad detects the Tag, a long beep will be emitted, and the LCD display will prompt you to enter a PIN
3