Product Info

18. Bracket Holes x 3
19. Mounting Holes x 4
20. Bottom Fixing Screw x 1
21. RFID Tag
Caution
 Wiring of the Remote Keypad should only be performed by certified technician with proper knowledge and
training in electric equipment.
 Before installation or any maintenance work, make sure the power supply of the Control Panel has been disconnected.
Features
 Battery and Low Battery Detection
 Two L91 1.5V AA lithium batteries can be installed inside the battery compartment to serve as a backup power source in
case of power failure. Prior to inserting batteries, ensure battery polarity is correct to protect your device.
 The Remote Keypad can also monitor battery life. When batteries are low on power, a low battery signal will be sent
along with regular signal transmission to the Control Panel to alert users for battery replacement.
<
<
N
N
O
O
T
T
E
E
>
>
 Only use specified batteries with the device. When replacing batteries, always replace the whole set, do not mix
.different types of batteries or new and used ones to avoid damaging the device.
 Power Saving Feature
 When idle, the Remote Keypad is in stand-by mode and consumes no power. It will wake up when any key is pressed.
 After entering User Menu, if neither of the Arm key/Home Arm key is pressed, the Remote Keypad will return to
stand-by mode within 5 seconds. If either or both of the Arm key/Home Arm key is/are pressed, the Remote Keypad
will return to stand-by mode within 20 seconds.
 After “Enter PIN Code” is displayed on the LCD screen, if no key is pressed, the Remote Keypad will return to stand-by
mode within 5 seconds.
 After the Mode Change request is submitted, if no signal is received from the Control Panel, the Keypad will return to
stand-by mode within 15 seconds.
 Upon completion of a command input, the Remote keypad will return to stand-by mode.
 Keypad Wiring
 The keypad terminal can be hardwired to the Control Panel. Up to four KPT-35-COMBOs can be connected in series
within 500ft (152m) in wire distance. Wire gauge: UTP, minimum 20 AWG, maximum 18 AWG.
 To connect KPT-35-COMBO to the Control Panel, open the front cover by using a Phillips screwdriver to loosen the
cover fixing screw.
 Before connecting the “V”, “G”, “A”, “B” terminals, remove the batteries in KPT-35-COMBO and make sure the power
supply of the Control Panel has been disconnected.
 Loosen KPT-35-COMBO’s “V” terminal and the Control Panel’s “VDD” terminal. Connect the “V” terminal to the “VDD”
terminal and tighten both terminal screws.
 Loosen KPT-35-COMBO’s “G” terminal and the Control Panel’s “GND” terminal. Connect the “G” terminal to the “GND”
terminal and tighten both terminal screws.
 Loosen KPT-35-COMBO’s “A” terminal and the Control Panel’s “458A” terminal. Connect the “A” terminal to the “458A”
terminal and tighten both terminal screws.
 Loosen KPT-35-COMBO’s “B” terminal and the Control Panel’s “458B” terminal. Connect the “B” terminal to the “458B”
terminal and tighten both terminal screws.
 Ensure the furthest keypad’s Jumper Switch and Control Panel’s J53 Jumper Switch are set to ON to serve as a
terminating resistor.
 Power on the Control Panel and wait for the “KPT-35 COMBO” shown on the Remote Keypad’s LCD screen.
2