User's Manual

d) When incorrect Keypad PIN code is entered to enter Test mode, The Keypad will emit 4 beeps. If incorrect Keypad

PIN codes are entered for 4 times, the Keypad will disable key input function for 1 minute and indicate error by

flashing all LEDs for 6 times and emitting 6 beeps. All key press during the next 1-minute period will be ignored.

After 1 minute, the Keypad will return to normal operation and emit a long beep to indicate

z Appendix

If you have forgotten the Keypad PIN Code or anything wrong happened in the Remote keypad, you can reset the Remote

keypad to factory default and reinitialize it.

Reset to factory default:

Step 1 Remove the batteries and release the tamper.

Step 2 Press & hold 3 key while inserting the battery back.

Step 3 Continue pressing 3 until three short beeps to indicate successful reset.

Step 4 Release 3 key, the reset process is complete.

<NOTE>

After reset, Keypad PIN code reverts to factory default values, 0000 and clears all user code and tag data. Remote

keypad will need a new learn-in process to start functioning.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.