Parts List

 Factory Reset

Resetting the Keypad to factory default will restore Keypad’s own PIN Code to 0000 and clear all panel learning memory.

Reset to factory default:

Step 1 Remove the batteries and release the tamper.

Step 2 If “Arm/Home with Control Panel PIN Code” method is selected, press & hold 3 key while inserting the battery

.back.

.If “Arm/Home without Control Panel PIN Code” method is selected, press & hold 4 key while inserting the battery

.back.

Step 3 Continue pressing 3 key until KP emit 3 beeps to indicate successful reset.

.Continue pressing 4 key until KP emit 4 beeps to indicate successful reset.

Step 4 Release 3 or 4 key, the reset process is complete.

 After reset, PIN code reverts to factory default values, 0000. Remote keypad will need a new learn-in

process to start functioning.

 Whenever the Keypad is removed from the Control Panel, it should be put to factory reset as well to clear

its Control Panel memory.

 Mounting Remote Keypad

To mount the remote keypad:

I. Remove the front cover.

II. Using the 2 mounting holes of the back cover as a template, mark off the positions in the most appropriate place.

III. Insert the wall plugs if fixing into plaster or brick surface.

IV. Screw the Remote keypad onto the wall plugs.

V. Replace the front cover.