Parts List

received. If remote keypad does not perform 3 beeps, please restart the learning procdeure.
Step 3. After the Remote keypad is learnt-in, put the Control Panel into Walk Test mode, hold the Remote keypad in the
desired location, and send the learning code to the Control Panel to confirm this location is within the signal range
of the Control Panel. To send the learning code, either press the
＊
key then 7 key under Test Mode or press
both # and
＊
keys together under Normal Operation Mode.
Step 4. When you are satisfied that the Remote keypad works in the chosen location, you can proceed with mounting the
Remote keypad following the steps described below (please refer to “Mounting Remote keypad” for details).
Step 6. Press Disarm key twice to leave Test mode and the installation is completed. Remote keypad will sound a
long beep and three system mode LEDs will turn off. The Remote keypad returns to Normal Operation mode.
<NOTE>
 The Remote keypad will automatically exit Test mode after 5 minutes of inactivity and return to Stand-by
mode. All the LEDs will turn off and the Keypad will emit one long beep.
 System Mode Control
After finish learning the Keypad into alarm system Control Panel, the user may change the system using Keypad.
There are two ways to arm the system.
I. Away Arm / Home Arm the system by entering Control Panel User PIN Code.
II. Away Arm / Home Arm the system without entering Control Panel User PIN Code.
Disarming the system always requires entering Control Panel User PIN Code.
Arm/Home/Disarm with Control Panel PIN Code:
Under Test mode, Pressing ＊ key and then 9 key to enable Arm/ Home with PIN Code function.
 Enter Arm Mode: Enter any one of Control Panel user code and press key. If panel has no fault and arming
is successful, the LED will turn ON along with a long beep.
 Enter Home Mode: Enter any one of Control Panel user code and key. If panel has no fault and arming is
successful, the LED will turn ON along with 3 beeps.
 Return to Disarm Mode: Enter any one of Control Panel user code and key. If disarm is successful, the
LED will turn ON along with 2 beeps.
If there is Alarm Memory, the LED and fault LED will turn ON along with 5
beeps.
Arm/Home/Disarm without Control Panel PIN Code:*+
In the Test mode, Pressing ＊ key and then 8 key to enable Arm/ Home without PIN Code function
 Enter Arm Mode: Press key. If panel has no fault and arming is successful, the LED will turn ON
along with one long beep.
 Enter Home Mode: Press key. If panel has no fault and arming is successful, the LED will turn ON
along with 3 beeps.
 Return to Disarm Mode: Enter any one of Control Panel user code and Key. If disarm is successful, the
LED will turn ON along with 2 beeps.
If there is Alarm Memory, the LED and fault LED will turn ON along with 5 beeps.
 Fault Conditions
When Remote Keypad is under NORMAL OPERATION MODE,
a) When fault condition exists within Control Panel, if the Keypad is used to arm the panel, the Fault LED will flash along
with 3 beeps to indicate fault condition.
b) When the Keypad disarms the panel, the LED will turn ON along with two beeps indicating normal operation.
c) If you input incorrect KP Pin code for 4 times under test mode, KP will disable the key function for 1 minute and all the
LEDs will flash 3 times along with 6 beeps. After 1 minute, it will emit a long beep to indicate that the key function is
back to normal.
3