Parts List

 Flash along with 2 beeps: Request for Home mode during Arm mode.
 Flash along with 3 beeps: Request for Home or Arm Mode when fault condition exists.
 Flash along with 4 beeps: PIN code was incorrect.
 General Operation
 Enter Test mode — Enter Keypad PIN code and then press ＊ key.
 Panic Alarm — Press 1 key + 3 key at the same time. (if the function is enabled)
 Fire Alarm — Press 4 key + 6 key at the same time. (if the function is enabled)
 Medical Alarm — Press 7 key + 9 key at the same time. (if the function is enabled)
 Check Control Panel Status — Normal Mode Press # key.
 Power
 Remote keypad uses one CR123 3V Lithium battery as its power source.
 Remote keypad can also detect the battery status. If the battery voltage is low, the Power LED will flash for 5 seconds
during operation. The Low battery signal will be sent along with regular signal transmissions to the Control Panel for
displaying the status accordingly.
 Before shipment, the battery is pre-installed by the factory.
 When changing battery, press any key a couple times to discharge before inserting new battery.
 Power Saving Feature
 When idle, Remote keypad is in Stand-by mode and uses no power. It will activate and wake-up for 5 seconds when
any key is pressed.
 After 5 seconds of key inactivity, the power goes off and it returns to Stand-by mode.
 Tamper Protection
 The keypad is protected against any attempt to open the lid or to detach keypad from its mounting surface.
 Tamper protection is disabled when the keypad is in Test Mode.
 Getting Started
Step 1. Put the Control panel into learning mode, .
Step 2. Adding remote keypad into the Control Panel:
Test Mode:
I. Put remote keypad in Test mode by entering KP PIN code (default: 0000), then press
＊
key.
The three LEDs will turn on along with a long beep.
II. Press ＊ key then 7 key to transmit leaning signal. Remote keypad will sound a long beep.
Test Mode Function:
I. Press ＊ key and then 2 key — Enable Dual-key Panic Alarm function
II. Press ＊ key and then 3 key — Enable Dual-key Fire Alarm function
III. Press ＊ key and then 4 key — Enable Dual-key Medical Alarm function
IV. Press ＊ key and then 5 key — Disable all Dual Key function (Default)
V. Press ＊ key and then 6 key — Edit Keypad Pin Code
..Enter Old Keypad Pin Code and then press
＊
key
..Enter New a new 4-digit Keypad Pin Code and then press # key.
VI. Press ＊ key and then 8 key — .Enable Arm/ Home without PIN Code function.
(Please refer to “Arm/Home without Control Panel PIN Code” for details, page 3).
VII. Press ＊ key and then 9 key — Enable Arm/ Home with Control Panel User PIN Code function (Default).
(Please refer to “Arm/Home with Control Panel PIN Code” for details, page 3).
<NOTE>
 If the remote keypad did not sound a long beep, it means the remote keypad did not send the learning
code to the Control Panel, please press ＊ key then 7 key again to send the learning code.
 If the Control Panel receives the learning code, it will display the info accordingly. Refer to the operation
manual of your Control Panel to complete the learn-in process.
 After Control Panel receives the signal from remote keypad, it will send an acknowledgement back to
remote keypad. The remote keypad will then beep 3 times to confirm the acknowledgement has been
2