Specifications

5
2.2. The Power Supply:
An AC power adapter is required to connect to a wall outlet. Be sure only to use an adapter with
the appropriate AC voltage rating to prevent component damage. DC 9V 1A switching power
output adaptor is generally used to power the Control Panel with 4.8V, 1100mAh Ni-mH
rechargeable battery pack and DC 12V 1A switching power is used to power the Control Panel
with 7.2V, 1600 mAh, Ni-mH rechargeable battery pack.
Rechargeable Battery
 HSGW-X-4B series includes 4.8V, 1100 mAh, Ni-mH rechargeable battery pack or
HSGW-X-6B series includes 7.2V, 1600 mAh, Ni-mH rechargeable battery pack (required
for or dongle option)
 In addition to the adapter, there is a rechargeable battery inside the Control Panel, which
serves as a backup in case of a power failure.
 During normal operation, the AC power adapter is used to supply power to the Control
Panel and at the same time recharge the battery. Slide the Battery Switch to ON to activate
and charge the battery. It takes approximately 72 hours to fully charge the battery
 The battery status information is displayed in the Panel section of local area webpage.
2.3. System Requirements:
The system requires a TCP/IP network environment for you to connect to the Control Panel for
system programming.
Hardware requirement for programming the panel vial LAN webpage:
 Microsoft Windows 98, ME, NT4.0, 2000, XP, Windows 7 or 8operating system.
 Microsoft Internet Explorer 6.x, or later and Mozilla Firefox 3.0 compatible.
 CD-ROM drive
 CPU: Intel Pentium II 266MHz or above
 Memory: 32MB (64MB recommended)
 VGA resolution: 800x600 or above