Specifications

40
 Confirm Sound: this is for you to decide whether to turn off/or adjust Control Panel
beeping sounds when changing Arm/Home Arm/Disarm mode.
 Warning beep: this is for you to decide whether the Control Panel will sound a warning
beep whenever a fault condition has been detected and displayed. The warning beep
will be silenced after the Fault message has been read by the user. When a new fault
condition is detected, it will then again emit a warning beep every 30 sec.
 Entry/ Exit Only Final Beeps: This is for you to determine when the Control Panel
should start warning beep during Entry or Exit countdown timer. For example, if the
setting is set to 5 seconds, the Control Panel will only stat warning beep during the last
5 seconds of Entry or Exit countdown timer. When set to Disable, the Control Panel will
sound warning beep during the entire Entry or Exit countdown timer.