Specifications

31
<NOTE>
 The Device Edit page is only available for the newest BX/Siren series and BX series
without DIP Switch.
Edit your Siren setting and information accordingly to instruction below. Click “OK” to save your
new changes when finished. Alternatively, click “Default” to reset all parameters to default
values or click “Reset” to re-enter all the information.
 Name: Enter a name for the Siren.
 Area: Select the area which the Siren belongs to.
 Zone: Select the Siren zone number.
 Attribute:
 Permanently Bypass: If checked, the Control Panel will completely ignore all signal
received from the Siren. A bypassed Siren will not be able to trigger any response,
including alarm or fault from the Control Panel. All other attribute settings will also be
ignored.
 Whole Area: if checked, all the Volume, Voice and Behavior functions will be
simultaneously enabled in Area 1 and Area 2.
 Volume:
 Alarm Sound: set the volume of the alarm sound of the Siren when alarming.
 Full arm confirm beep: set the volume of the confirm beep sound of the Siren when