Specifications

code.

 For IP Camera VST-1818 Series, press and hold the Privacy button for 10 seconds.

Step 4. When the system received the signal transmitted from device, the screen will display its

information for selection.

<NOTE>

 It takes 5-10 seconds for the Control Panel to receive a learn code from or Z-Wave

Sensor.

Step 5. Click “Add” to include selected device into panel. If the sensor you wish to learn into

already exists in the system, the sensor information will be displayed in the Learned

Device section. If not, the sensor information will be displayed in the Detected Device

section.

Step 6. If the device is successfully learnt into the system, the added device will be displayed in

the “Learned Device” section.

Step 7. Repeat Step 3~5 to learn in all device, click Stop to exit learn mode when complete.

The system will automatically exit Learn mode if left idle for 5 minutes.

5.1.2. Local Learning

Instead of learning devices via configuration webpage, you can also learn in devices by using

the learn button located on the back of Control Panel.

Step 1. Press and hold the Learn Button on the back of Control Panel for 10 seconds, release