Specifications

13
5. Device Management
The Device Management section allows you to learn in, edit, control and view all available
accessory devices that can be included in the HSGW Series Control Panel.
5.1. Learning
Use this function to add new devices into the Control Panel. HSGW Series supports up to 160
zones of accessory devices, in 2 areas, up to 80 zones each area.
The following types of accessory devices are supported:
 RF device: All Climax RF devices are supported. (For only model, RF devices are not
supported.)
 device: All device with Home Automation 1.2 profile are supported.
<IMPORTANT NOTE>
 The Control Panel built-in module supports up to 40 devices by itself. If you wish
to include more than 40 devices into the Control Panel, you must add extra
Routers into the Control Panel’s network to increase the network’s maximum device
capacity.
 IP Cameras: The Control Panel is compatible with Climax VST-1818 Series IP Camera. Up
to 6 IP Cameras are supported.
 Z-Wave Device: Available for Z-Wave modules only, other modules requires additional
USB Z-Wave Dongle.
5.1.1. Add Sensor
Step 1. Click on “Learning” to enter learn page.
Step 2. Click on “Start” to enter learning mode.
Step 3. Press the test or learn button on the each device or any button on the Remote
Controller. (Please refer to each sensor’s user manual for test or learn button position).
<NOTE>
 For sensors, press and hold the learn button for 10~12 seconds to transmit a learn