User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. Program the System
- 7. Network Settings
- 8. System Settings
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
401 – Remote Arm/Disarm
When the system is armed or disarmed by SMS message or web access
407 – Disarm/Away Arm/Home Arm by Remote Keypad
408 – Set/Unset Arm/Disarm
When the DC set at Set/Unset is triggered.
456 - Partial Arm
When partially arm the system from Disarm to Home arm
570 – Device out of order/Door Contact Not Closed
When arm fault type is set as Direct Arm, any device is out of order after the preset exit
delay time is reached.
When arm fault type is set as Direct Arm, Door Contact is not closed after the preset
exit delay time is reached.
602 – Periodic test report
When the control panel makes periodic Check-in reporting.
616 – Call Request
When the service call is activated by VST-809.
693 – Cross Zone First Trip
When a sensor set to Cross Zone is triggered to start Cross Zone Timers.
694 – Cross Zone Timeout
When Cross Zone Timer expires after the alarm has been verified.
695 – Fire Verification Timeout
When Fire Verification Timer expires.
87