User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. Program the System
- 7. Network Settings
- 8. System Settings
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
6.3. PIN Code
The User PIN Codes are used by Remote Keypad accessory to control system mode remotely.
The 2 areas in the control panel have 60 User PIN Codes available for setting. Each consists of
4-6 digits (numeric number 0~9), no disallowed PIN code. User PIN code #1 is always activated
factory default.
User PIN #1 in Area 1, 2
Password: 1234
User Code Setting
User Code: Enter the 4-digit code in the field.
Tag Number: The number indicates the tag which is associated to the user code. By
applying a tag to the tag sensor zone of Remote Keypad and clicking the Load button,
the corresponding tag number will be loaded.
Area: Select the area for setting User PIN Code.
User Name: Enter a user name for easy recognition of system events. Up to 17
alphanumerical characters are allow for each user name.
Latch:
Latch Latch Report ON = Whenever the User PIN Code is used to change
system mode, the panel will report the event.
Latch Latch Report OFF = When the User PIN Code is used to change system
mode, the panel will not report the event.
Delete: Check the box if you want to delete selected user. User#1 in each area cannot
be deleted
After finish all setting, click OK to confirm change.
43