User's Manual

Control Panel is put into Full Arm Mode.
 Home arm confirm beep: set the volume of the confirm beep sound of the Siren when
Control Panel is put into Home Arm Mode.
 Disarm confirm beep: set the volume of the confirm beep sound of the Siren when
Control Panel is put into Disarm Mode.
 Exit beeps of full arm: set exit countdown beep volume under Full Arm Mode.
 Exit beeps of home arm: set exit countdown beep volume under Home Arm Mode.
 Entry beeps of full arm: set entry countdown beep volume under Full Arm Mode.
 Entry beeps of home arm: set entry countdown beep volume under Home Arm Mode.
 Door Chime: set the volume of the Door Chime sound (Ding-Dong Sound).
 Voice:
(The following functions are only available for SRV devices):
 Doorbell: set the volume of the ring tone when pressing the button on the Video Door
Phone (VDP).
 Fault beep: set the volume of the voice played when system is force armed under fault
conditions.
 Pre-alarm (outdoor IR warning beeps): set the volume of the voice played when an
outdoor burglar sensor(Door Contact, IR) is triggered.
 Behavior
(The following functions are only available for RF modules):
 Burglar trigger in home arm: Enable or Disable whether Siren is activated when an
alarm is triggered under Home Arm.
 Burglar trigger in full arm: Enable or Disable whether Siren is activated when an alarm is
triggered under Full Arm.
 Strobe activation: Enable or Disable Siren LED strobe activation.
 Confirm flash: Enable or Disable Siren LED flash when system Armed/Disarmed.
 Exit flash: Enable or Disable Siren LED flash during an exit countdown period.
 Entry flash: Enable or Disable Siren LED flash during an entry countdown period.
 Trigger flash: Enable or Disable the flashing from the Siren LED when alarming.
 Alarm-in-memory sound: Enable or Disable Alarm in Memory sound.
 Fault sound: Enable or Disable system fault sounds.
34