User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. Program the System
- 7. Network Settings
- 8. System Settings
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
5.5. Exclusion
This feature is only available for Z-Wave modules only, or when a Z-wave dongle is inserted into
the Control Panel. This feature is for you to remove Z-Wave device only.
Step 1. Click on “Exclusion” and click on “Start” to start the procedure. Then the Panel will
enter the removing mode.
Step 2. Refer to the Z-Wave device manual to transmit signal.
Step 3. Select the desired Z-Wave and click delete to remove it from the Z-wave list under
Device List section (Panel). Then the Control Panel will remove the Z-Wave device.
26