User's Manual
Table Of Contents
- Table of Contents
- 1. Introduction
- 2. Panel Information
- 3. Getting Started
- 4. Connection to Panel Webpage
- 5. Device Management
- 6. Program the System
- 7. Network Settings
- 8. System Settings
- 9. Event & History
- 10. Appendix
- Federal Communication Commission Interference Statement
Step 7. (Optional)You can choose to edit the panel’s network setting by clicking on the panel
column, then click “Configure Setting”
The LanType is default to DHCP and does not require manual input of
IP/Netmask/Gateawy/DNS setting. If you wish to configure these setting manually,
change LanType to Static.
After finish changing network setting, enter the user name (default: admin) and
password (default: cX+HsA*7F1) then click OK to confirm. The user name and
password can be changed later in panel configuration webpage
Step 8. Click the panel information column and click on “Open Web Page”, or double click on
the panel column to link to the panel configuration webpage. Your default browser will
start automatically to connect to the LAN IP displayed in Finder.
12