User's Manual

3. Getting Started

Read this section of the manual to learn how to set up your Control Panel and program System

Settings over the Web page.

3.1. System Deployment

Follow guidelines below when planning installation location:

 The Control Panel requires Ethernet connection.

 The Control Panel should be installed at a location that is hidden from outside view.

 Avoid mounting the Control Panel near large metal objects which may affect wireless radio

strength.

 The Control Panel should be protected by sensors so that no intruder can reach the Control

Panel without first activating a sensor.

 Home Automation devices (Power Switches…etc) do not have this limit and can be used

with any Router.

3.2. Hardware Installation

Step 1. For configuration and operation of Control Panel via Ethernet, connect the IP cable to

the RJ-45 connector.

Step 2. It is recommended to disable the SIM card PIN code and backup your SMS messages

before inserting into the Control Panel. The panel will delete the SMS messages after

it is powered on.

Step 3. To disable SIM Card PIN Code on Android smartphone, access your smartphone’s

Settings Menu -> Security -> Setup SIM Card Lock.

Step 4. Tap the SIM PIN toggle switch. Enter current SIM PIN code if prompted.

Step 5. Insert your SIM card into the base.

Step 6. Connect the Power Adaptor to a Wall Outlet and the other end to the Control Panel.

After several seconds, the Control Panel will emit 2 beeps to indicate that the system

is now operational.

<NOTE>

 Please make sure the GPRS/MMS function of GSM SIM Card is open.

 If the SIM Card is changed or removed, please power off the panel then power on

again.

 If a GSM fault occurs, please re-insert the SIM card and then reset the GSM in GSM

setting page.