User's Manual

Device section. If not, the sensor information will be displayed in the Detected Device

section.

<NOTE>

 For VST-862 F1 devices, press and hold the learn button for 3 seconds for the Control

Panel to receive a learn code, and then click “Add” within 30 seconds.

Step 6. If the device is successfully learnt into the system, the added device will be displayed in

the “Learned Device” section.

Step 7. Repeat Step 3~5 to learn in all device, click Stop to exit learn mode when complete.

The system will automatically exit Learn mode if left idle for 5 minutes.

5.1.2. Local Learning

Instead of learning devices via configuration webpage, you can also learn in devices by using

the learn button located on the back of Control Panel.

Step 1. Press and hold the Learn Button on the back of Control Panel for 10 seconds, release

when the Control Panel emits one short beep. LED 1 Green will turn ON to indicate the

Control Panel is now in learning mode

Step 2. Press the test or learn button on each device to transmit signal, refer to device manual

for detail.

Step 3. When the Control Panel receives signal from device, it will emit 2 beeps to confirm. The

device will be included in the panel automatically.