User's Manual
12-AUG-2011
2
complete the process.
D. Battery Life
The Fall Sensor uses one 3V lithium battery as its power source. The Fall Sensor will have a typical
battery life of 2 years at an average of one activation a day.
If the battery voltage is low, a Low Battery signal will be sent to the Control Panel to notify the user.
Moreover, when it s operated in low battery status, the Red LED will Flash to remind the user to replace
the battery.
<
<
N
N
O
O
T
T
E
E
>
>
) It is prohibited to learn-in Fall Sensor to the Control Panel when Fall Sensor is in low battery
status.
E. Inactivity Detection
If a fall is detected, the sensor will transmit an alarm signal (CID event code: 120) to Control Panel. If no
sudden movement within 10 seconds after fall detection, an inactivity code (CID event code: 102) will be
sent to Central Monitoring Station to notify CMS of user’s inactivity condition.
F. Usage Recommendation
1. If a fall sensor is placed steadily in one position for more than 3 hours, a sleep timer-1 minute will be
activated. During one-minute sleep time, the fall sensor will not be triggered due to put-on movement.
After 1 minute, the fall sensor will be back to normal function.
2. Please place a fall sensor outside of a coat. Do not cover it with any clothes.
3. Carefully place the fall sensor on a desk when you are not using it in order to avoid triggering an alarm.
G. Testing
During testing, do not trigger the fall sensor twice within a 10-second interval.
F
F
C
C
C
C
S
S
t
t
a
a
t
t
e
e
m
m
e
e
n
n
t
t
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
F
F
C
C
C
C
C
C
a
a
u
u
t
t
i
i
o
o
n
n
:
:
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance may void the user's authority to operate this equipment. (Example - use only
shielded interface cables when connecting to computer or peripheral devices).