Installation Guide

Table Of Contents

FPHubInstallationGuideVersion1.0Published6/15/18 4

4. AddingSensorsandPeripherals

SecuritySensors

SecuritySensorscanonlybeaddedtothesystemlocallyviaaLearnModebasedsensoridentification.

1. PressandholdtheAutoLearnbuttonfor10secondsuntilthepanelemitsaone‐tonebeepto

indicateithasenteredLearnMode.ThetopLEDwillturnsolidGREENtoindicatethepanelisin

learnmode.

2. Triggereachdevicefollowingthe procedureinthedeviceinstallationmanual.

3. Whenthepanelreceivesasignalfromthedeviceitwillemitatwo‐tonebeeptoindicatethatit

wassuccessfullylearnedintothepanel.

4. Whenalldevicesarelearnedin,pressandholdtheAutoLearnbuttononthepanelforone

secondtoexitlearnmode.Thepanelwillemitatwo‐tonebeepandtheLEDSwillturnoffto

indicateithasreturnedtoitsnormalmode.

5. Configurethesensorsremotelyviaawebportal.

7. WalkTestandDeviceMounting

Oncealldevicesarelearnedin,placethedevicesintheirfinallocationsandrunawalktesttoensure

thatalldevicesaresignalingproperlyintheirfinallocations.

WalkTest

1. EnterWalkTestmode,topLEDwillblinkGREENwhileinWalkTestmode

2. AssensorsareActivated,theiractionwillappearonscreenandthesensorwillemitatwo‐tone

beep

3. Afterallsensorshavebeentriggered,selectEndWalkTesttoexitwalktestmode.

a. IfasensortriggerdidnotregisterontheWalkTest,trymovingitclosertothecontrol

panelandtriggeritagain.Ifthedeviceworksthen,tryusinganRFrepeatertoextend

therangeofthecontrolpanel.

DeviceMounting

Oncedevicesaresignalingintheirfinallocations,theycanbemountedaccordingtotheinstructions

providedwitheachdevice

5. SystemProgramming

Thesystemsettingscanonlybeprogrammedremotelyviaawebportalorapp.

6. Regulatory

FCCID:GX9FPHUB3-1