User's Manual

USER MANUAL
BTX Ankle Tether
3.0 INSTALLATION INSTRUCTIONS
3.1 BTX A NKLE T ETHER
1. If necessary, open battery cover and install battery making sure to note + and –
placement. Screw down battery cover to “hand tight” using Bit Driver with Phillips bit.
2. Insert t (arrow) end of strap into s (arrow) side of BTX and secure
using two pins. The slot in the top of the pin should be perpendicular
to the strap and the raised side of the top on the strap side. Push
down pins with thumb or finger until seated and a “click” is heard.
3. Size to offender’s ankle and cut strap on cut line using Strap
Cutter. Never cut the t (arrow) end of strap.
4. Secure BTX on offender’s ankle by inserting other end of strap into the BTX and using
two pins as described in Step 2 above.
3.2 T RACKING /R EPORTING U NIT - TRU
5. Power on TRU and start TetherTrack application.
6. When SCANNING is displayed on screen push START Button on BTX on offender.
7. TRU will display the BTX number(s) (BTX – XXXXXX) that are in range.
If more than one BTX is displayed, scroll to the BTX you want
to pair with using the TRU’s Navigation Key. Push OK. Make
sure BTX number on display matches BTX number on offender.
8. If prompted: TetherTrack Requests User Location Permissions, push GRANT.
9. If prompted: Grant Request, select Always and push OK.
10. When pairing is complete, TetherTrack will suspend. Press OK to resume and display
the Status Screen. The application is operational while suspended.
6