User's Manual

28
determine the operation range of the devices.
Step 1. From Idle mode, press and hold the
RESET button for 6 seconds.
<
<
N
N
O
O
T
T
E
E
>
>
 Once pressed, a button beep sound
will be heard. CTC-1041RV will emit
one short beep at 3 sec., then a
double beep when it reaches 6 sec.
Step 2. Release the button after you heard the
double beep. Then, a short beep will
be heard indicating CTC-1041RV is
now in Learning Mode. The RED
LED begins to flash.
Step 3. Move the device to your desirable
location in the house, and press the
TEST button or Pendant button
(WTRB) to observe the range for its
operation.
Step 4. If CTC-1041RV responds with one
long beep, then the particular device
is within the operation range.
<
<
N
N
O
O
T
T
E
E
>
>
For Talking Pendant WTRVS: During
Walk Test, when the Pendant button is
pressed you will hear WTRVS emit beep
(1s-on / 1s-off). After about 3 sec, the
Control Panel will emit a long beep. About
2 sec later, the Control Panel will emit a
long beep again, indicating the Pendant is
within the operating range. If you do not
hear beeps emitted by Control panel, turn
the Pedant off and repeat the steps
mentioned above until you hear the Panel
beeps.
Step 5. To exit Learning Mode, press both
RESET & HELP buttons
simultaneously.
Or, CTC-1041RV will exit Learning
mode automatically after 5 mins of
inactivity.
4.4. Global Test
 Global Test is used to test if the complete
system is working properly.
To do the Global Test:
Step 1. Press the RESET button once.
Step 2. Within 5 sec, press Pendant
button.
Step 3. CTC-1041RV will emit a short
beep and report to Monitoring
Center.
<
<
N
N
O
O
T
T
E
E
>
>
 This function is for WTR only, not for
WTRVS.
4.5. Factory Reset
CTC-1041RV will clear all programmed
parameters by the following sequence:
Step 1. Unplug the power cord from the DC
Jack.
Step 2. Remove the Battery Switch rubber
cap.
Step 3. Use a pen or screw-driver to slide the
Battery Switch to OFF position (or the
opposite direction of the ON marking)
Step 4. Plug the power cord into the DC jack
while holding down both the HELP &
RESET buttons, until one long beep
is heard, indicating that the Factory
Reset is successful.
Step 6. Release both buttons
Step 7. Slide the Battery Switch back to ON
position again.
Step 8. Replace the Battery Switch rubber
cap.
<
<
N
N
O
O
T
T
E
E
>
>
 Once the Fatory Reset is executed,
all the programmed data is returned to
its default value and all the devices
that have been learnt-in are removed.
You will have to do the programming
and learn-in the devices one-by-one
again.