User's Manual

20
 Enter (99) and (#), after one short beep,
CTC-1041RV exits the Programming Mode
and returns to idle mode.
4. Operation
4.1. Idle Mode
When the system is in Idle Mode, CTC-
1041RV is ready to execute the following
functions:
4.1.1. Auto-Answer Incoming Phone
Calls
This function is only available when Command
#31 is set as ON (factory default is OFF).
 For an Incoming telephone call, CTC-
1041RV will emit cycles of 2 quick beeps.
 User can answer the call either by
pressing the Pendant Button or the RED
HELP BUTTON on CTC-1041RV.
 The user can also remotely answer the
call by pressing the Pendant Button on
WTRVS or by pressing the Emergency or
Service button on CTC-808RV.
 Once CTC-1041RV answers the call, it will
open a Two-Way Voice Communication.
The RED HELP BUTTON illuminates.
 In the “Two-Way” and “Talk Only”
communication modes, press (6) or
(4) to increase or decrease the levels
of speaker volume.
<
<
N
N
O
O
T
T
E
E
>
>
 If levels of speaker volume can only be
adjusted in the two-way or talk only
communication mode, the adjusted
value will be kept at next use.
 The value of speaker volume ranges
from 1 to 8 and the default value is set
as (5).
 If communication is set up between
WTRVS/CTC-808RV and the
emergeny call recipent, the speaker
volume level cannot be adjusted.
 To hang-up, press and hold the
Pendant Button for 5-8 seconds again
or the RESET button on CTC-1041RV.
 1 to 10 minutes (set by Command 46)
is allowed for each call.