User's Manual

17
methods.
 The supervision function does not cover
WTRVS.
Command 66
Set Guard Time Delay Time for Fall
Sensor
 This command is used to set the guard
time delay time for fall sensor.
 CTC-1041RV can be programmed to delay
alarm reporting (triggered by Fall Sensor)
from (00) (instant reporting) to (99)
seconds.
 During this time period, a continuous series
of beeps will be emitted to alert user.
 If a false alarm is triggered by Fall Sensor,
it can be cancelled within the Guard Time
Delay.
Function
Selection
Result
(00) INSTANT REPORTING
(01) - (99) DELAY
 Factory Default is (15), 15 SECONDS.
<
<
N
N
O
O
T
T
E
E
>
>
 This command is used if a fall is
detected.
 If an emergency alarm is triggered by
pressing the Active Button on Fall
sensor, the system will report an alarm
immediately.
Command 67
Setting the Help Arrived Timer
 This command is used to set the
countdown timer for CTC-1041RV to
resend the alarm report if no help has
arrived after the initial report is made
(meaning the reset button has not been
pressed before the timer expires).
Function
Selection
Result
(01)-(15) 1-15 MINUTES
 Factory default is (15), 15 MINUTES.
<
<
N
N
O
O
T
T
E
E
>
>
 The Help Arrived function (Command
33) must be set as ON for this function
to work.
Command 75
Help Not Arrived Call
 When CTC-1041RV has sent an alarm
report and help not has arrived after 4
retries, CTC-1041RV will dial the phone
number programmed by Command 75 and
open two-way communication when the
call is answered.
 Enter the (telephone number) followed by
(#) to program the telephone number.
<
<
N
N
O
O
T
T
E
E
>
>
 When you program the phone number,
entering () will cause a 3-second
pause. () is for a switchboard
system, extension, etc.
 The telephone number can contain up
to 20 digits, including ().
 The Help Arrived function (Command
33) must be set as ON for this function
to work.
 CTC-1041RV only dials this telephone
number once. If this phone call fails,
CTC-1041RV will not try again.
Command 80-84
Remove Devices
 CTC-1041RV can be programmed to
remove ALL previously learnt devices by
entering (80) followed by ( ＃
＃＃
＃ ). The system
will emit an acknowledging beep over the
phone for the user.
 Command (81) is used to remove Pendant
# 1 (learnt-in by Command 91)
 Command (82) is used to remove Pendant
# 2 (learnt-in by Command 92).
 Command (83) is used to remove Silent
Wrist (learnt-in by Command 93).
 Command (84) is used to remove Other
Devices (learnt-in by Command 94).
<
<
N
N
O
O
T
T
E
E
>
>