User's Manual

14
 During two-way communication, you
can use DTMF command to switch the
communicating method. Please refer to
section 4.2. Alarm Activation.
 The first digit of Access Code must be
entered within 15 sec. Otherwise,
CTC-1041RV will disconnect the call
automatically.
 To terminate the call, press DTMF (9)
or RESET BUTTON on CTC-1041RV.
 If the 5-minute waiting period is up,
CTC-1041RV will automatically exit
this waiting mode and return to idle
mode.
 Command #41 (Auto Answer for
Remote Programming) will not be able
to proceed during the 5-mins Call-
back time.
Command 39
Dialing Mode
 This function is for you to select the dialing
method of your telecommunications.
 There are two dialing methods available for
user:
Function Selection Result
0 TONE
1 PULSE
 Factory Default is set as (0), Tone.
Command 40
Set Access Code
 The Access Code is used to enter
Programming Menu (locally or remotely),
and the Call-Back Function.
 It consists of 4 digits and has been set to
(1111) as factory default. Before you set
your own Access Code, (1111) must be
keyed in.
 To set a new Access code; enter the
desired (4-digit number) in Function
Selection.
Command 41
Auto Answer for Remote Programming
 CTC-1041RV can be programmed to auto
answer incoming phone calls after a pre-
set number of rings have been reached.
The number of rings range from (00) (no
auto answer) to (32) rings.
Function Selection Result
(00) OFF
(01) - (32) ON
 Factory Default is (20) Rings.
<
<
N
N
O
O
T
T
E
E
>
>
 If 00 is selected, it means CTC-
1041RV cannot auto-answer the call
by ring count. If you want to do
Remote programming, please follow
the Remote Programming method
described in System Conifuration, I.
Entering Programming Mode: 2.
Remote Programming Mode.
Command 43
Periodic Test Call
 CTC-1041RV can be programmed to make
test calls periodically from (00) (no test call)
to every (1) - (7) or 30 days:
Function Selection Result
(0) OFF
(1) - (7) 1 - 7 DAYS
(8) 30 DAYS
 Factory Default is set as (0), OFF.
<
<
N
N
O
O
T
T
E
E
>
>
 Whenever programming mode is
accessed, CTC-1041RV will reset the
Periodic Test Call timer.
 Periodic Test Call will only function
with telephone numbers assigned to
Digital reporting method in Command
20-24.