User's Manual

11
will automatically enter specific
Follow-On and/or Call Back Mode as
specified by Command (38).
 If Speech Method is selected:
After the dialing for alarm/emergency
trigger is successful, CTC-1041RV
opens a two-way voice communication
between the Call Recipient and CTC-
1041RV for 1-10 minutes (set by
Command #46).
If the Call Recipient needs more talk
time, they can press any keys except
9 on their phone set to add another 1-
10 minutes (set by Command #46).
To terminate the call, press (9) or
RESET BUTTON on CTC-1041RV.
Command 31
Ringer Enable for Incoming Calls
 CTC-1041RV can be programmed to emit
a ring tone as an audio alert, or silent for
incoming calls.
Function Selection Result
(0)
OFF
(Ring Tone Disable)
(1)
ON
(Ring Tone Enable)
 Factory Default is set as (0), OFF.
<
<
N
N
O
O
T
T
E
E
>
>
 If the function is set to ON, you can
answer the incoming call by pressing
the RED HELP BUTTON or Pendant
Button.
 The time-out period for the incoming
call is 1 to 10 minutes (set by
Command 46). During the
communication, CTC-1041RV will
emit two beeps via the telephone
handset to alert the call recipient the
remaining time of 20 & 10 sec.
 Press any DTMF keys (except
DTMF#9) can extend another 1 to 10
minutes (set by Command 46)
 To terminate the incoming call: (1)
press the green reset button on CTC-
1041RV; or, (2) press DTMF #9 from
the call recipient’s end.
Command 32
Audible Fault Alert
 CTC-1041RV can be programmed to emit
detected and existent Fault Alert Beeps at
every 30 sec.
Function Selection Result
(0)
OFF
(No Warning Beep)
(1)
ON
(With Warning Beep)
 Factory Default is set as (0), OFF.
 The fault situations include AC failure, line
failure or battery damage.
Command 33
Help Arrived Signaling
This function is only available for the digital
Contact ID reporting method.
 This function will be activated in the
following situations:
 When the Red Help Button is pressed.
 When the button on WTRVS or Fall
Sensor is pressed.
 When a fall is detected.
 When Night Switch’s Red Button is
pressed.
It is used for the Monitoring Center
personnel to confirm if the help has arrived
for the user or not.
 If Help Arrived Signaling is set to ON, once
the Alarm Reporting is completed, the
RED HELP BUTTON will start to flash.
Press the GREEN RESET BUTTON when
the Help arrives, and CTC-1041RV will
report to monitoring center and the RED
BUTTON will stop flashing.
 If Help Arrived Signaling is set to OFF,
once the Alarm Reporting is completed,
CTC-1041RV will return to idle mode.