Service manual

CLIMATEMASTER WATER-SOURCE HEAT PUMPS
Vertical Stack
Rev.: 11/09/12
26
ClimateMaster Water-Source Heat Pumps
Hose Kit & Chassis Installation
Remove
Hose Kit Installation - After cabinets are installed,
remove the upper and lower panels. SAVE THESE FOR
RE-INSTALLATION AFTER THE CHASSIS IS INSTALLED!
The cabinet has one or two shipping braces across the
front (Figure 15) remove and discard both braces.
Step 1: Remove (2) Panels and Shipping Braces
Figure 15
Step 2: Attach the Flex Hoses. Unpack and examine
hose kit. Remove all shipping and/or packing material
such as rubber bands, plastic caps, and styrofoam. Hose
kit should contain (2) hoses (Figure 16).
Figure 16
Locate the valves inside the unit cabinet marked WATER
IN and WATER OUT (Figure 17). Apply Tefl on tape to the
male pipe thread end of each hose (Figure 16). Attach
the hoses to the water valve. Always use a back-up
wrench when tightening the hose to the valve
(Figure 18).
Figure 17
 WARNING! 
WARNING! Under no circumstances should any part of the
hose itself be gripped or twisted by hand, pliers, channel
locks or any other tool. Leakage or bursting may occur!
Always use a back-up wrench when tightening the hose.
 CAUTION! 
CAUTION! If the risers are under pressure, do not open shut
off valves until installation is complete!