Service manual

CLIMATEMASTER WATER-SOURCE HEAT PUMPS

Vertical Stack

Rev.: 11/09/12

ClimateMaster Water-Source Heat Pumps

Chassis Pre-Installation

1. Check chassis data plate. Verify chassis is correct for

cabinet.

2. Check for any shipping or handling damage. Make

repairs or adjustments.

3. Verify refrigerant tubing is free of kinks or dents and

that it does not touch other unit components.

Step 1: Remove the six screws from the very bottom of the sides, three

from each side as shown above.

The chassis is now ready for installation.

All TRM models (except TRM15 G Voltage) are ready for installation

Figure 13: TRM 15 G Voltage compressor shipping screw removal

Shipping Screws

4. Inspect all electrical connections. Connections must

be clean and tight at the terminals.

5. Replace any panels or covers removed for steps 2-4.

6. Remove compressor shipping clips, brackets or screws

per steps below. Always keep chassis upright.

The chassis is now ready for installation.