Owner`s manual

MULTI-APPLIANCE TOUCH PAD

Controls – Installation / Setu

/ Commissionin

Ducted Gas Central Heating

ETTING FAN SPEEDS – HIGH / LOW

There are 2 available fan speed setting options for ducted gas central heating as set out on the Fan Speed

Options Chart. Minimum fan speed should be set so that the heater does not go out on over temperature.

NOTE: fan speed settings should ONLY be set by a qualified installer or service technician

Fan Speed Options

Installer Maintenance Parameter Default Value Range

Low Fan Speed 1 27 0 – 35

High Fan Speed 2 35 0 – 35

High Fan Speed – Dual Cycle AC 3 35 0 – 35

To enter into the installer maintenance to adjust minimum and maximum fans speeds, the following steps

must be followed.

Step 1 Ensure the control is in the OFF mode.

Step 2 A series of unseen icons must be pressed

1. Press and hold the ZONE 4 (1) icon

allowing for a triple BEEP followed by a

single BEEP.

2. In quick succession press the unseen

SETUP icons ENTER (2), REVIEW (3) &

CLOCK (4).

If successfully executed the clock area

will display tP:01.

3. If unsuccessful repeat 1 and 2 of STEP 2.

Step 3 Using the to select H 01 or if

Dual Cycle cooling is fitted HC 01 from the

clock display area.

Step 4 Press ENTER. The display will now change to

1 27 or any other previous setting.

Step 5 Using the to select the

parameter to be changed. Press ENTER. The

heater will begin operation.

NOTE:- Wait for the heater to be fully

functional before adjusting the fan speeds.

Step 6 Using the to change the

value / fan speed setting. Press ENTER to

save the revised setting.

Step 7 To change the other fan speed parameter repeat Step 5 – 6.

Step 8 Press FINISH to exit.

Bonaire Control Systems

Page 49