Owner`s manual

MULTI-APPLIANCE TOUCH PAD

Controls – Installation / Setu

/ Commissionin

Using the Setup Modes

There are a series of available parameters that can assist the installer to set the unit up to specification

and tailor the control to meet the customer’s requirements. Carefully read these tables before entering the

maintenance modes. These set up features cover Ducted Evaporative Air Conditioning, Ducted Gas

Central Heating and Dual Cycle Refrigerated Air Conditioning.

Important Note: Changes made to the set up modes outside the parameters set by your installer

could have an adverse effect on the unit operation and life. Warranty could also be void.

The Setup modes include:

Coding – All products

Diagnostics – All products

Fan Speed Settings – All products

Zoning Setup – Heating / Dual Cycle Cooling

Zone Setup – Multiple Evaporative Air Conditioners

Water Management – Evaporative Air Conditioning

RODUCT IDENTIFICATION

The setup mode will cater for many options of heating / cooling unit configurations. As a result there are a

number of potential product classes that the touch pad control system will control. The class is the first

requirement for selection when coding or entering the setup mode.

Class Appliance Class Code

tP Touch Pad Wall Control tP:01

H Heater H:01,02,03,04

E Evaporative A/C E:01,02,03,04

HC Combined Heater –

Dual Cycle Cooler

HC:01,02,03,04

For standard domestic applications with a single unit or heater cooler combinations the following default

classes will be used:

Ducted Gas Heating Only HC 01

Ducted Gas Heating c/w Dual Cycle Refrigerated Air Conditioning HC 01

Ducted Evaporative Air Conditioning E 01

Ducted Gas Heating and Evaporative Air Conditioning. HC 01 & E 01

Bonaire Control Systems

Page 38