Owner`s manual

１９
２．
３．
４．
●
●
Air purging and leakage test
Outdoor condensation drainage (Heat pump type only)
When the unit is heating, the condensing water
and defrosting water can be drained out reliably
Installation: Install the outdoor drain elbow in 25
hole on the base plate,and joint the drain hose to the
elbow, so that the waste water formed in the outdoor
Ø
Fig 13
Fig 14
1. Remove the nut cover at the shutoff valve.
2. Align with the center of the fitting pipe and manually
tighten the conical nut sufficiently.
3. Use spanner to tighten the conical nut.
4. Remove the liquid valve cap, the gas valve cap and
the nut of refrigerant charging mouth.
5. Use inner hexagon spanner to twist off the liquid valve
body and at the same time use screwdriver to open
the valve core of the liquid valve. Now gas shall flow
out.
6. After gas continues flowing out for about 15 second
and refrigerant gas begins to flow out, close the valve
core and tighten the nut of refrigerant charge mouth.
7. Completely open the valve body of the liquid valve
and the gas valve. （See Fig 13）
8. Turn and tighten the valve cap, then use soap water
or a leak detector to check if there is gas leakage at
the outdoor and indoor units and the pipeline
connections.
9. If conditions permit, use a vacuum pump to exhaust
air in the unit from the valve core. （See Fig 14）
Gas Pipe
Gas Valve
-76cmHg
Liquid Pipe
Liquid Valve
Inner Hexagon Spanner
Refrigerant Charge Mouth
Screwdriver
manifold valve
Multi-meter
Manometer
Hi handle
Lo handle
Charging hoseCharging hose
Low-pressure valve
Vacuum Pump
Chassis
Outdoor drain elbow
through the drain hose.
Ｉｎｄｏｏｒ ｕｎｉｔ ｔｅｒｍｉｎａｌ ｂｏａｒｄ
Outdoor unit terminal board
wire
leakage test
BlueYellow-green
Diagram for cooling
and hea
ting unit
Ｂｌａｃｋ
Ｂｒｏｗｎ
Installation service- Install outdoor unit
Electric wiring
１．
Remove the front side plate.
Take off wire clamp. Connect and fix power connect cord to
terminal of line bank. Wiring should fit that of indoor unit.
Fix the power connection cable with wire clamp, for cooling
and heating unit, then use the wire clamp to fix the signal
control wire, then connect the corresponding connector.
Ensure wire has been fixed well.
Note:
Wrong wiring may cause spare parts
malfunction.
After the cable fixed, make sure
there should be a free space between
the connection and fixing place on the
lead wire.
unit can be drained out to a proper plate.
Air purging and
Power connection
Brown
Blue
Black
Yellow-green
Power connection
Wire clamp
wire
The signal control wire is only
fit for cooling and heating unit
Front side plate