Specifications

MT-01 Indice 0 Page 38
4. INTELITHERM UNIT
INTELITHERM TECHNICAL MENU
This sub-menu is mainly used for factory testing and configuration purposes.
ONLY INTENDED FOR TECHNICIANS
You shall bear full responsibility for
any modification you make to the sub-menu
that cause a fault.
On the other hand, in the event of technical interventions, you can give this
document to an approved technician or your supplier's after sales team who
can request a code from Climadiff to grant them access to the menu
Display
Description
- CONFIGURATION -
MENU TECHNIQUE
(TECHNICAL MENU
CONFIGURATION)
To enter this menu simultaneously press both of the buttons until you hear an audible sound
> TECHNIQUE <
OFFSET TEMP (OFFSET
TEMPERATURE SETTING)
Temperature compensation: stagnation temperature set at the factory.
Please note: This function is only available to technicians and other authorised persons.
> TECHNIQUE <
TEST COMPRESSEUR
(COMPRESSOR TEST
SETTING)
This menu is used to test the compressor by enabling it to manually switch ON and OFF. This
tests the electronic control of the compressor.
Please note: This function is only available to technicians and other authorised persons.
> TECHNIQUE <
TEST RESISTANCE
(RESISTANCE TEST
SETTING)
This menu is used to test the resistance by enabling it to manually switch ON and OFF. This tests
the electronic control of the resistance.
Please note: This function is only available to technicians and other authorised persons.
> TECHNIQUE <
DYNAMIQUE TEXTE
(DYNAMIC TEXT)
In this menu it is possible to authorise any automatic changes to the basic message in the main
menu. When "Texte Fixe" (set text) is selected, the screen permanently displays the internal
temperature. When "Texte Auto" (automatic text) is selected, the screen alternatively displays
the wine cabinet's internal temperature and the status of the controller. Default mode: "Cave à
vin" (wine cabinet) or another name that has been selected.
- TECHNIQUE -
EXIT (exit setting)
To return to the main menu, you must ensure you have definitely exited the programming
menu: Navigate this menu using the [ ] button until you see the message CONFIGURATIONS
EXIT (exit configuration), then simultaneously press both of the buttons until you hear two
beeps. This will return you to the device's main display menu, enable the new settings to be
applied and the device to be controlled.
!
!