User Manual

www.climacoolcorp.com
2
Pre-Installation
Inspection
Upon receipt of equipment, carefully check the shipment
against the bill of lading and inspect each chiller for any
damage incurred during shipment. Thoroughly check for
any visible damage of control panels and electrical
and/or refrigeration components or broken copper lines.
The carrier must make proper notation of any damages or
shortages on all copies of the bill of lading and complete
a common carrier inspection report prior to your nal
acceptance of the shipment. Note: It is the responsibility
of the purchaser to le all necessary claims with the
carrier. In addition, please notify the ClimaCool Customer
Service Department at 405.815.3000 or customerservice@
climacoolcorp.com of all damage immediately.
Storage
Chillers should be stored in an upright position and kept in a
clean, dry area.
Handling of Modules
Carefully remove the module’s packaging. The chiller’s steel
base cutouts provide maneuverability by forklift or pallet
jack into its nal position (See Rigging and Lifting Procedures
on page 7). Verify that all header grooved couplings and
mounting hardware kits are on site prior to connecting
the modules. Note: Consult factory for handling other than in
the upright position.
Rigging and Lifting
Each module should be lifted using a pallet jack or fork
lift. If it is necessary to utilize a crane for rigging or lifting,
each module shall be lifted using lifting straps and spreader
bars using rigging points identied on Rigging and Lifting
Procedures on page 7.
Warranty
To ensure proper equipment longevity, design performance
and reliability, all ClimaCool chillers must be installed,
operated and maintained in accordance with ClimaCool IO&M
manuals. Water quality is of the utmost importance for the
proper care and maintenance of your modular chiller system.
Regular treatment of the water will increase longevity of your
system. Failure to provide adequate ltration or treatment
of evaporator and condenser water will void the ClimaCool
module’s warranty. A factory authorized technician is
required to perform the startup of your ClimaCool chiller.
Please contact the ClimaCool Customer Service Department
at 405-815-3000 or [e-mail] to
schedule. There is a minimum of 3 weeks’ notice required to
schedule your factory startup.