User manual

8/11
OPERATION
Before Use
• Check that the Exhaust Hose has been mounted properly (see ‘Installation’ section). If the exhaust
Hose is not correctly used, hot air will blow back into the room you are trying cool
• Check that the drain plug at the bottom rear of the unit is securely plugged in, to prevent water leaks
(see page 9 – Water Drainage)
• Check that the local mains power matches that shown on the rating label of the unit
• Check that the location of the unit is suitable (flat, stable surface; away from sources water / heat)
• If the unit has recently been transported, let it stand for 6 hours to allow the compress contents to
settle
Cooling Mode
Press the “Mode” button till the “Cool Mode” icon appears.
Press the “▲”or“ ▼”button to select a desired room temperature. (16 - 31 )
Press the “Fan Speed” button to select wind speed.
NOTE: During hot days, the unit will cool off the room most efficiently by setting the temperature at the lowest
and the fan speed at the highest. Reducing the length of the exhaust hoses, insulating the exhaust hoses,
and keeping direct sunlight to a minimum will also improve the cooling efficiency.
Heating Mode
Press the “Mode” button till the “Heat Mode” icon appears.
Press the “▲”or“ ▼” button to select a desired room temperature. (16 - 31 )
Press the “Fan Speed” button to select wind speed.
Dry (De-humidifying) Mode
Press the “Mode” button till the “Dry Mode” icon blinks
Set the selected temperature to current room temperature minus 2 . (16 - 31 )
Set the fan motor to LOW wind speed.
AUTO Mode
According to the current room temperature the unit will automatically select the mode - cooling, dehumidifying
or heating.
When the room temperature is <23 the unit will enter Heat Mode
When the room temperature is 23C – 26C the unit will enter Dry Mode
When the room temperature is 26 the unit will enter Cooling Mode
Timer Mode
Timer ON setting
When the air-conditioner is OFF, press the “Timer” button and select a desired ON time through the
temperature and time setting buttons.
“Preset ON Time” is displayed on the operation panel.
ON time can be regulated at any time in 0-24 hours.
Timer OFF setting
When the air-conditioner ON, press “Timer” button and select a desired OFF time through the temperature
and time setting buttons.
“Preset OFF Time” is displayed on the operation panel.
OFF time can be regulated at any time in 0-24 hours.