Instructions / Assembly

13
Troubleshooting
The unit does not turn on
Problem Problem
Make sure the unit is plugged into a
standard 120V grounded power
source. Press the power button on
the control panel.
Flame effect is on, but there is no
ame efect
Open the top and back panel to
check if the ame spindle has
fallen off from the spindle motor.
The heater does not blow warm air Make sure the set temperature is
higher than the room temperature.
The heater does not work Turn all switches to OFF and
unplug the unit for 5 minutes.
Plug the unit back to power and
operate as normal.
Error Code E3 shown on theindicator Reset the unit by unplug the
unit from power source for 5
minutes and then plug it back.
Remote control does not work Use it closer to the unit /
change battery.