Installation Guide

WARNING: Do not move or remove the mesh trim panel, when
the appliance is plugged in and operating. This will cause the
remote control and touch panel to no longer function.
NOTICE: When the heater is turned on for the first time, a slight
odor may be present. This is normal and should not occur again
unless the heater is not used for a long period of time.
NOTICE: To improve the heater's performance, aim the remote
control at the front of the fireplace. DO NOT press the buttons too
quickly. Give the unit enough time to respond to each command.
POWER
Flame Increase (+)
Flame Decrease (-)
Heater Power
Heater I
Heater II
Turn the appliance ON/OFF.
NOTE: Make sure the main switch
fireplace is turned on before operating.
Control Flame brightness.
7 Settings: Press the flame brightness
increase“+”Button or the flame
brightness decrease“-”Button to adjust
to your desired brightness.
Control the Heater ON/OFF.
Press the“HEATER POWER" Switch to on
or off the unit heater.
Control the Heater.
Press button to initiate the heater.
(OFF) no heater or blower.
“I ", heater blows warm air(750W)
" I", heater blows hot air(1500W)
NOTE: Heater functions cycle
from(OFF)( I )( II )
4.3 REMOTE CONTROL
Move the battery's transparent insulating piece away before
using.
Battery must be recycled or
disposed of properly. Check
with your Local Authority
for recycling advice in your
area.
5.0 TROUBLE SHOOTING GUIDE
PROBLEM SOLUTION
Heater doesn't
turn on with
the power
switch.
1. Main Power supply
switch is off.
Turn the main power
supply switch to “ON”
position.
2. Circuit breaker has
been tripped.
Too many appliances
are on this circuit.Be
sure that the electrical
supply for this unit is
an independent circuit.
3. Heater is unplugged
from the wall outlet.
Make sure the power
cord is plugged into a
functioning and
properly grounded 15
Amp 120V AC
electrical outlet.
15 16