Installation Guide

2.0 ELECTRICAL INSTALLATION NOTES
2.1 GENERAL INSTRUCTIONS
CAUTION - Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
A. Prior to plugging your appliance into an electrical outlet, verify
that the house circuit breakers for the outlet are on.
B. The appliance may emit a slight, harmless odor when first used.
This odor is normal and caused by the initial heating of internal
appliance elements, and the odor will not occur again.
C. If your appliance does not emit heat, consult the operation
section of this manual for further information.
D. Use with an ETL or UL certified surge protector.
RISK OF FIRE! THE POWER CORD MUST NOT BE PINCHED
AGAINST A SHARP EDGE. SECURE CORD TO AVOID
TRIPPING OR SNAGGING TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR PERSONAL INJURY.
DO NOT RUN CORD UNDER CARPETING. DO NOT COVER
CORD WITH THROW RUGS, RUNNERS, ETC.
ARRANGE CORD AWAY FROM CLUTTERED AREAS AND WHERE IT
MAY BE TRIPPED OVER.
RISK OF FIRE. TO PREVENT A POSSIBLE FIRE, DO NOT BLOCK AIR
INTAKE OR EXHAUST IN ANY MANNER. DO NOT USE ON SOFT
SURFACES WHERE OPENINGS MAY BECOME BLOCKED.
RISK OF FIRE. DO NOT BLOW OR PLACE INSUL ATION AGAINST
THE APPLIANCE.
THIS ELECTRIC APPLIANCE IS TESTED AND LISTED FOR USE ONLY
WITH THE APPROVED OPTIONAL ACCESSORIES.
Follow all National and local electrical codes.
USE OF OPTIONAL ACCESSORIES NOT SPECIFICALLY TESTED FOR
THIS ELECTRIC APPLIANCE COULD VOID THE WARRANTY AND/OR
RESULT IN A SAFETY HAZARD.
IF THE INFORMATION IN THESE INSTRUCTIONS IS NOT
FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR DEATH. DO NOT STORE OR USE
GASOLINE OR OTHE RFLAMMABLE VAPORS IN THE VICINITY OF
THIS OR ANY OTHER APPLIANCE.
THIS APPLIANCE IS HEAVY. IT IS HIGHLY RECOMMENDED THAT
TWO PEOPLE INSTALL THIS APPLIANCE.
HEATER VENTS ON THE ELECTRIC APPLIANCE CANNOT, IN ANY
WAY, BE COVERED. AS IT MAY CREATE A FIRE HAZARD.
1. The heaters should be installed only using the mounting
brackets we provided if you want to mount them.
2. The heater must not be recessed in the ceiling. There must be
enough space around the top of the heater to ensure adequate
ventilation.
3. The heater should be at least 60cm/24 inches away from any
surrounding walls.
4. A distance of at least 90cm/36 inches should always be left in
front of the heaters to ensure safety.
5. The heater must be located neither directly below nor in front of
a socket-outlet.
6. The heater must be installed to prevent any control switches
from being touched by anyone who is in the shower or bath.
7. Make sure that there is no possibility of inflammable material,
combustible material or curtains coming into contact with the
heater, there is a risk of fire if this happens.
8. DO NOT LEAVE THE HEATER UNATTENDED DURING USE.
09 10