Installation Guide

6.1 PARTIALLY REFLECTIVE GLASS CLEANING

DISCONNECT POWER AND ALLOW HEATER TO COOL

BEFORE ATTEMPTING ANY MAINTENANCE OR CLEANING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR

DAMAGE TO PERSON.

THE FIREPLACE SHOULD NOT BE OPERATED WITH AN

ACCUMULATION OF DUST OR DIRT ON OR IN THE UNIT, AS THIS

CAN CAUSE A BUILD UP OF HEAT AND SUBSEQUENT EVENTUAL

DAMAGE. FOR THIS REASON THE HEATER MUST BE INSPECTED

REGULARLY, DEPENDING ON CONDITIONS AND AT LEAST AT

YEARLY INTERVALS.

The partially reflective glass is cleaned in the factory during the

assembly operation. During shipment, installation, handling,

etc., the partially reflective glass may collect dust particles;

these can be removed by dusting lightly with a clean dry cloth.

To remove fingerprints or other marks, the partially reflective

glass can be cleaned with a damp cloth. The partially reflective

glass should be completely dried with a lint-free cloth to prevent

water spots. To prevent scratching, do not use abrasive cleaners.

6.0 MAINTENANCE

Power

supply

lamp PCB

for log

lamp PCB

for flame

SYNCHRONIZED MOTOR

Fan-Motor

Heater Element

Temperature Limit

Thermostat (With PTC)

POWER

Switch

HEATER

Switch

Adjustment

Voltage

Ouput PCB

Adjustable

Resistor

N1 N L L1

6.2 SCHEMATIC DIAGRAM

21 22