Assembly Instruction 1
Tabletop Fire Pit ITEM #: WFEHFP-04-A / WFEHFP-04-B MODEL#: F180040-A1 / F180040-B2 ANS Z21.97 CSA 2.41-2017 Outdoor Decorative Gas Appliances Maximum inlet supply pressure: 13 inch w.c. (3.24 kPa) Minimum inlet supply pressure: 8 inch w.c. (1.99 kPa) INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference DANGER FIRE OR EXPLOSION HAZARD If you smell gas: Shut off gas to the appliance. Extinguish any open flame. If odor continues, leave the area immediately.
IMPORTANT SAFETY INFORMATION 1. This appliance is for outdoor use only, and should NOT be used in a building, garage or any other enclosed area. 2. Do NOT operate, light or use this appliance within ten feet (3.05 m) of walls, structures or buildings. 3. For residential use only. This outdoor firepit is NOT for commercial use. 4. Do NOT use this outdoor firepit for indoor heating. TOXIC carbon monoxide fumes can accumulate and cause asphyxiation. 5.
IMPORTANT SAFETY INFORMATION j. A fire causing serious injury or damage to property may occur if the above is not followed exactly. 16. Your outdoor firepit has been checked at all factory connections for leaks. Recheck all connections as described in the “Operating Instructions” section, as shipping can loosen connections. 17. Check for leaks even if your unit was assembled for you by someone else. 18. Do NOT operate if a gas leak is present. Gas leaks may cause a fire or explosion. 19.
IMPORTANT SAFETY INFORMATION 40. Certain areas of this outdoor firepit when in use will become too hot to touch. To avoid burns, do NOT touch hot surfaces until the unit has completely cooled, unless you are wearing protective gear (such as insulated pot holders or heat-resistant gloves/mittens). 41. Do NOT leave a lit outdoor firepit unattended, especially around children and pets. 42. Do NOT hang or place clothing or other flammable material on or near this appliance. 43.
PACKAGE CONTENTS PART# DESCRIPTION A Fire pit body B Lava rock (1.1 lbs) QUANTITY 1 1 bag B A ASSEMBLY INSTRUCTIONS 1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all parts are present before beginning assembly of product. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. 2.
4. Connecting propane cylinder (See Figure 3) Only cylinders marked “propane” may be used. NOTE: Some 1 lb cylinders may form frost when near empty. ( 1 ). Before connecting, be sure there is no debris caught in the head of the burner or burner or burner ports. ( 2 ). Make sure the control knob is in the “ OFF” position. ( 3 ). Lubricate the threads of the regulator with petroleum jelly. Line up threads on the propane cylinder with regulator. ( 5 ). Insert the propane cylinder. ( 6 ).
6. Place the lava rocks (B) into the fire pit body (A). Approx lava rock 1.1 lbs of lava rocks are needed (See Figure 5) . NOTE: leave the pilot box uncovered by lava rock. CAUTION: this fire pit is equipped with natural lava rock that may crackle or pop the first time it is used. Lava rock has been pre-heat treated. However, in rare cases on first time use, lava rock may pop or burst causing small pieces of hot rock to fly out of the fire pit.
OPERATING INSTRUCTIONS WARNING: Failure to inspect this connection or follow these instructions could cause a fire or an explosion which can cause death, serious bodily injury or damage to property. Cylinder/Gas line connection 1. Make 2-3 oz. of leak detection solution by mixing one part liquid dishwashing soap with three parts water. 2. Make sure regulator/control knob is in the “OFF” position as shown (See Figure 7). 3. Apply the leak detection check solution on the “X” location as shown (See Figure 6).
6. Push and turn control panel counterclockwise to “High” position (See Figures 8). 7. Use a match or a lighter to light the fire bowl. 8. Adjust flame to desired height with the control knob. 9. After lighting, observe the burner flame Make sure all burner ports are lit and flame height matches illustration (See Figures 9-11). 1 in - 10 in 2.5cm-25.
CARE AND MAINTENANCE CAUTION: 1. All cleaning and maintenance should be done when outdoor firepit is cool and with the fuel supply disconnected. 2. Do NOT clean any outdoor firepit part in a self-cleaning oven. The extreme heat will damage the finish. 3. Do NOT enlarge valve orifices or burner ports when cleaning the valves or burners. NOTES 1. This outdoor firepit should be thoroughly cleaned and inspected on a regular basis. 2. Abrasive cleaners will damage this product. 3.
WARRANTY Firepits Burner, steel fire pit bowl, all mechanical parts and fittings to control panel and burner assembly, and all fire pit tops that are not cast aluminum are warranted for a period of one (1) year from original date of purchase, against defects in material and or workmanship. Rust is not covered. Frames Frames are warranted to be free from defects in materials and workmanship for a period of one (1) year.
