Installation Guide

【
【
【
【Instruction
Instruction
Instruction
Instruction for
for
for
for Remote
Remote
Remote
Remote Controller
Controller
Controller
Controller and
and
and
and Switch
Switch
Switch
Switch Panel
Panel
Panel
Panel】
】
】
】
Control Panel / Remote Control Operation
(Control panel POWER switch must be ON to use remote control.)
POWER
TOP LIGHT
TIMER
13 colors ( L01,L02...L12,L13) Flame dims from L01 to L13.:
Controls Flame change.
3 colors
.
( F0 OFF-F1 yellow-F2 blue-F3 purple-cycle) :
Controls Top light colors.
9 Settings: (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h,9h) Press button
until reach desired setting.
.rimeT Controls the
FLAME
TER AHE
NOTE: Heater functions cycle from OFF-LO-HI
(HI), heater blows hot air (1500W)
(LO), heater blows warm air (750W)
(OFF) no heater or blower.
.rPress button to initiate the heate
.rControls the Heate
The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will
appear on the bottom of the fireplace control panel.
WARNING : Do not move or remove the mesh trim panel, when the appliance is plugged in and
operating. This will cause the remote control and touch panel to no longer function.
Power ON/OFF
Heat setting
Flame setting
Top light setting
Timer Setting
Turns the appliance ON/OFF.
Flame log setting
Cycle by cycle.
TIMER
FLAME LOG
Controls Flame log change.
13 colors : ( C01,C02...C12,C13) Flame dims from C01 to
C13.Cycle by cycle.
Power ON/OFF
Flame setting
Flame log setting
Top light setting
Heat setting
Timer Setting
Control with App
You can operate the BI-Z series with a smartphone.
Download the "Xaralyn Smart" app in the Playstore or
Appstore and create an account in order to use all functions.
To enter pairing mode，press the "Flame setting " button on
the fireplace for 10 seconds.then follow the instructions
displayed in the app.
You can keep pressing “Flame setting” button for 10 seconds
to connect to the mobile APP.