Installation Guide

LIGHTING INSTRUCTIONS

Make 2~3 oz. of leak solution by mixing one part liquid dishwashing detergent and three parts water. Noted:

make sure control knob is “OFF”.

Apply several drops of solution where the cylinder attaches to regulator (See Figure 7), inspect the solution

at the connection looking for bubbles. If NO bubbles appear, the connection is secure. If bubbles appear, the

connection has the leak, disconnect the regulator, reconnect, perform another leak check. If you continue to

see bubbles after several attempts, cylinder valve is defective and should be returned to cylinder’s supplier.

Apply several drops of solution where gas valve attaches to bellows (See Figure 8), where gas valve attaches

to hose (See Figure 9), and where inlet tube attaches to bellows (See Figure 10). If NO bubbles appear, the

connections are secure. If bubbles appear, the connection has the leak, disconnect, reconnect,perform

another leak check. If you continue to see bubbles after several attempts, the part is defective and should

replace the part.

1. Push in gas control knob slightly and turn to “OFF”.

2. Turn gas control knob the “ON/MIN”.

3. Push in gas control knob all the way and hold. ontinue to press the ignition button for 15 seconds.

4. If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5 minutes before

attempting to light the burner again, repeat step 1 to 3.

WARNING: For your safety, read and follow the Lighting Instructions in this manual and in the Rating Plate on

the appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR EXPLO-

SION HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.

TO TURN OFF GAS

1. Push in gas control knob slightly and turn to “OFF”.

To perform a leak test:

gas valve-hose connection (Figure 9) inlet tube-bellows connection (Figure 10)

Figure 11

gas control knob

ignition button