Standard Features The following are standard features of this system. Some vehicles may require optional parts/wiring and a few are incompatible with some features.
Welcome to the world of high-technology vehicle security and convenience C ongratulations on the purchase of your Clifford Electronics mobile security/convenience system. Clifford Electronics has long been recognized as the leading manufacturer of high-technology vehicle security systems. Our commitment to technological innovation, quality and reliability is clearly evident in your Clifford system.
Adding new remote controls For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Clifford Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters listed on the front cover) and program them into the system yourself. Tazor 4 will respond to as many as four remote controls. NOTE: Clifford G4 systems will respond only to G4-type ACG 2 re mote con trols.
PlainView 2 Coded Valet Mode All car alarms have a valet mode that turn off the security features. This mode is often used to turn off the alarm if the system is not responding to the remote. However, thieves can disable other alarm brands by simply hotwiring the ignition and flicking the alarm’s easy-to-find “hidden” valet switch. In contrast, your Tazor 4 system has safeguards that ensure a thief cannot enable the valet mode as a way of “turning off” your system.
Dual-Zone Piezo Sensor The Dual-Zone Piezo Sensor detects theft-related vibrations/ impacts and triggers the alarm. It also has a warning zone that detects less serious occurrences —such as someone bumping your car door with their’s—and sounds a brief warning tone. If needed, sensitivity of this sensor can be readjusted by any Authorized Clifford Dealer (preferably your installing dealer).
High-Output Siren This siren has these features: n Remote siren silencing: If triggered by a non-threatening event, you can silence the siren without remotely disarming. Press button while the siren is sounding. Two chirps confirm that the sensor activated the alarm and the system is remaining armed. Four chirps confirm that the system is still armed, but that the ignition is on or the hood, trunk or a door is open and that this may indeed be a genuine theft attempt.
If you opted to have the Clifford DataPort interface connector installed with your system, you can use our CliffNet Wizard software to access your system through your Windows PC. CliffNet Wizard will show you, on your PC screen, all your user-programmable feature settings. You can change settings simply by mouse-clicking the graphical button for each feature.
If you wish to reset all the user-selectable features to their normal factory presets, you can do so simply by choosing the Reset all features selection (column 1, row 7) on the Table of User-Selectable Features. If you do so, all features — except the programmed remote controls and your valet code — will be reset to the factory settings that are indicated in BOLD type on the Table of User-Selectable Features . To reset all remote controls, use the Clear all remotes feature in column 2, row 6.
