AMX58 Owner's Manual
AMX58 Owner's Manual
Standard Features þ þ þ þ þ þ þ þ þ þ þ þ þ þ Lifetime Warranty — We guarantee the operation of the control unit and remote controls for as long as you own your car (see the enclosed warranty card for details). A Pair of 2-Button/3-Channel Remote Controls — These remotes allow you to command your system from up to 100 feet away. User-Friendly Programming — All programmable features are accomplished with a few flicks of the valet switch.
þ Previous Intrusion Alert — Audibly warns you if the alarm was triggered while you were away. þ Specific Zone Intrusion Identification — The flashing LED identifies which zone was triggered in your absence. þ Automatic Malfunction Override — Automatically bypasses a malfunctioning trigger or sensor, then monitors all other points to continue protecting your vehicle. User Programmable Active/Passive Arming — The alarm system þ can be programmed to arm with the remote control or arm itself automatically.
Operating Instructions n Remote Control — Each of the pair of remote controls is a miniature radio transmitter with a typical range of up to 100 feet. Obstructions, radio interference, cellular transmissions or a weak remote control battery may reduce the range or interrupt transmission. (If the system does not immediately respond, release and press the button again. This works better than holding the button down.) The second remote can be used by a second driver, or kept as a spare.
n Remote-Controlled Silent Arm/Disarm — Press remote buttons #1 and #2 at the same time. n Silent Arm Indications. The parking lights will flash twice, the doors will lock, the starter will be disabled* and the LED will flash slowly. n Silent Disarm Indications. The parking lights will flash once, the doors will unlock, the starter will be enabled and the LED will turn off.
n To Turn off Protected Valet Mode 1. Turn your ignition key to the "ON" position or start the vehicle. 2. Flick the valet switch to the "OFF" position, 3. The LED will turn off to indicate the alarm is no longer in Protected Valet Mode. n User Programmable Passive Door Lock — The system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from accidentally being locked in the vehicle.
n Specific Zone Intrusion Identification — If the alarm had been triggered in your absence, the siren will chirp 3 times upon remote disarm (Previous Intrusion Alert). When you enter the vehicle and turn on the ignition, the LED will flash in cycles to specifically identify which zone has triggered the alarm. LED One Flash...One Flash... Two Flash...Two Flash... Three Flash...Three Flash...
n How to Interpret the Chirps and Parking Light Flashes When you press the remote control buttons, the system will respond with chirps (unless you have the chirp muting feature turned on or the system is in Valet Mode) and flashes of the parking lights to indicate the system status.
User-Programmable Features All system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. The system also allows you to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. 1. Remove the system from Protected Valet Mode.
Programming Table for Remote Controls Arm/Disarm/ Remote Panic Factory Setting Channel 1 Button 1 Accessory (-) Output Channel 2 Button 2 9 Press any remote control button you choose to operate this feature. Siren will chirp twice for confirmation. Silent Arm/Disarm Channel 3 Buttons 1 & 2 10 Press any remote control button you choose to operate this feature. Siren will chirp 3 times for confirmation. One-Step Code Learning — 11 Press button #1. The siren will chirp 4 times.
© Copyright Prime Security 1998 AMX58 Owner's Manual 31-3274/98
