Datasheet

SPECIFICATIONS
CUSTOMER MODEL NO. / TITLE
OPTICAL RECEIVING JACK OC806R
(4) Vibration and shock
This module is plastic sealed and has its wire fixed by resin. This structure is relatively resistant to
vibration and shock. In actual equipment, there are sometime cases in which vibration, shock, or
stress is applied to soldered parts or connected parts, resulting in lines cut.
A care must be taken in the design of equipment which will be subject to high levels of vibration.
(5) Support pins
The OC-0806R has support pins in order to fix itself to the PCB temporary. Please make the hole
for these pins in the PCB under the condition described in board layout hole pattern.
(6) Panel attachment
OC-0806R has hole for panel attachment. Please be sure to attach it to panel with self-tapping
screw.
(7) Solvent
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not
to pour solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean
it off using cotton tips.
(8) Supply voltage
Use the supply voltage within the recommended operating condition (Vcc = 5±0.25V). Make sure
that supply voltage does not exceed the maximum rating value of 7V, even for an instant.
(9) Interface
The OC-0806R has a TTL interface. It can be interfaced with any TTL-compatible C-MOS IC.
(10) Output
If the receiver output is at low and is connected to the power supply, or if the output is high and is
connected to GND, the internal IC may be destroyed.
(11) Soldering condition
Solder at 260℃ or less for no more than ten seconds.
(12) Repeated operation:
Inserting and withdrawing shall be made at a speed of 20 times or less/min using mating plug
(Refer to clause 4). 500 times.
W
R
T
N
CLIFF ELECTRONIC COMPONENTS LTD
A
P
V
D
SPECIFICATION NO.
FC684206R
C
H
K
D
C
H
K
D
PAGE： 6 OF 11
DATE： OCT.28.2003
REV. NAME DATE REMARK